53 Chevy

We did all the sheet metal work in this 53 Chevy. The Pans, the Firewall, and the Transmission Tunnel. We mocked up the motor and transmission. We cut the entire floor out, trunk pan, and the convertible compartment. Where the convertible top sets we reconstructed all of the sheet metal. Everything was built on an Art Morrison Chassis. The trunk pan was installed in three different sections. We bead rolled it for aesthetics. We mini tubbed it to accommodate a wider tire. We made the transmission tunnel to go all the way back, to get the car lower and have clearance for the transmission and driveshaft. We welded in 1 by 2 square tubing for seat mounts, and altered the dash to fit the column.



0624101059a.jpg
0624101059b.jpg
0624101059c.jpg
0624101100a.jpg
0810101309e.jpg

0810101310a.jpg
0810101310b.jpg
0810101310c.jpg
0810101310d.jpg
0810101311a.jpg

0810101311b.jpg
0812101301a.jpg
0812101302a.jpg
0812101433a.jpg
0812101433b.jpg

0812101434a.jpg
0812101434b.jpg
0903100952a.jpg
0903100952b.jpg
0903100952c.jpg

0903100952d.jpg
1116101145a.jpg
1116101145b.jpg
1116101145c.jpg
1116101150a.jpg

1116101150b.jpg
1116101151a.jpg
1116101151b.jpg
1116101151c.jpg
1116101154a.jpg

1116101154b.jpg
1116101154c.jpg
1116101202a.jpg
1116101202b.jpg
1117100700a.jpg

1117100700b.jpg
1117100701a.jpg
1117100701b.jpg
1117100701c.jpg
1117100701d.jpg

1117100701e.jpg
100_5897.JPG
100_5898.JPG
100_5899.JPG
100_5900.JPG

100_5901.JPG
100_5902.JPG
100_5903.JPG
100_5904.JPG
100_5906.JPG

100_5908.JPG
100_5909.JPG
100_5910.JPG

2797 Highway 11 South | Athens, TN 37303 | (423)252-0161 | mountainsidewelding@yahoo.com
Copyright © All rights reserved